Configuration and precautions of mold temperature controller Regular inspection of equipment

If the temperature of themold temperature controller exceeds the set value of the controller during production, the controller will open the solenoid valve and connect the water inlet pipe until the temperature of the hot fluid, that is, the temperature of the mold, returns to the set value. If the mold temperature is lower than the preset value, the operation panel will turn on the electric heating device. The principle of CLOUD precision machine is composed of water storage tank, heating and cooling system, driving power transmission system software, liquid level gauge automatic control system, temperature sensor, injection port and other equipment.

Generally, the thermal fluid in the transmission and distribution system software is pumped from the built-in heater and cooling tower from the storage tank to the rolling mill, and then from the rolling mill to the rolling mill, and the temperature sensor accurately measures the temperature of the thermal fluid and transmits the data to the control board; the mold; Themold temperature controller regulates the temperature of the hot fluid and indirectly the temperature of the rolling mill.

Themold temperature controller is used to adjust the equilibrium strain rate of the mold temperature, which can increase the temperature and reduce the temperature. Themold temperature controller uses a high heat transfer medium in order to send out the excess heat of the mold in a very short time. After the thermodynamic cycle temperature is set, the system temperature can be automatically controlled within a small deviation range to maintain a stable value.

The configuration of themold temperature controller and the configuration of the mold should be comprehensively defined according to the raw materials for production and processing, the net weight of the mold, the required heating time and the production efficiency kg/h. Operators must observe these safety requirements when using heat transfer fluids for CLOUD machines: do not place themold temperature controller near a heat source (furnace); use conical and pressure-resistant hose or rigid tubing; regularly check the temperature control loop (mold temperature controllers, connectors and molds) for leaks and function; and regular replacement of thermal oil to extend life.